![]() ![]() If you do too, try putting the graphics to medium and to not use Tab to view the microfilm. I had some problems with the game crashing in this part. >Move your cursor onto the orb right in front the you, click and hold, the light will turn red and trigger a cutscene > Use the arrow keys to enter the following first three symbols, then just go to the last and use the right arrow key three times till it triggers the cutscene Click and hold, the light will turn blue and trigger a cutscene > Move your cursor onto the orb till the light starts flickering red. Now you are back in the text adventure mode you already know from the first chapter of the game. Click and hold, the light will turn blue and trigger a cutscene. > Click on the handle on the left side of the test Chamber > Click on the round silver button on th Signal Generator, hold and move your mouse upwards till it reads 1000HZ > Move the slider on the Signal Generator up to the Square Wave (topmost symbol) > Click on the round button of the AMP, hold and move your mouse upwards till you reach the middle line on the display scale > Click on the round silver button on th Signal Generator, hold and move your mouse upwards till it reads 500HZ Click on the round button, hold and move your mouse upwards till you reach the first line on the display scale Click the silver slider to put it in Sinus Wave mode (middle symbol) Click on the round silver button, hold and move your mouse upwards till it reads 250HZ. > Type 455 into the numpad of the LZR II Laser > type 510 into the numpad of the LZR II Laser > Change the Tv Unit to RGB mode by clicking on the silver slider two times > Switch on the LZR II Laser and type 650 into the numpad > The Sync Master will start blinking green. ![]() > Switch the Tv Unit on (red-ish button in the bottom left corner of it) and put it in the xray setting by clicking the silver slider under the screen twice ![]() > Click on the small black pentagonal switch in the middle of the CC86 Xray to load it > Press Tab to get to the equipment screen > Wait a few seconds or type anyhting, a cutscene plays > The Sync Master will start blinking green.– look at photos (Achievement “Photos Of Another Time”) > Put the TV Unit in the RGB setting by clicking the silver slider under the screen twice > Put the TV Unit in the xray setting by clicking the silver slider under the screen twice > Click on the round silver button on th Signal Generator, hold and move your mouse upwards till it reads 360J > Click on the round silver button on th Signal Generator, hold and move your mouse upwards till it reads 200J Click on the round button, hold and move your mouse upwards till it's on full charge Click on the round silver button, hold and move your mouse upwards till it reads 100J Go around the corner and through the door from which the light shines in > Go to the end of the hallway and exit through the double door. On a side table you find the last cassette. > Go back to the hallway and enter the Pre-Surgery room. On the file cabinets you find the third cassette. > Go back to the hallway and enter the Office. On the chair in the far left corner is the second cassette. At the wall next to the door to Ward 4 is a dispenser for hand sanitizer. > Go back to the hallway and around the corner. On the file cabinet in the corner you find the first cassete. > You find the room names above the doors! > Move your cursor onto the orb right in front of you, click and hold, the light will turn red and trigger a cutscene ![]()
0 Comments
Leave a Reply. |